Close

Not quite sure about what you are looking for?

Use the links below to jump directly to the most searched topics

Good protection

Double seals protect bearings and motor from water and mud

Robust

Cast-iron housing

Easy operation

No damage if running without load

Sump pumps and Sludge pump

Sump pumps

Our sump pumps are of the centrifugal type, pumping fluid by means of an air driven impeller. The pump should be immersed in the liquid to be pumped. The liquid will leave the pump through the outlet port. These pumps are designed for high performance and durability.

Chicago Pneumatic pneumatic pumps

Both models will pump down to within only (0.87 in) from the base. They require no priming and can be run continuously, or even run dry, without overheating. They can be totally submerged, using a non-return valve on the exhaust pipe or an extended pipe ending above the level of the liquid.

The pumps can be used in places where abuse and rough use are inevitable or acceptable in terms of increase in productivity. They are relatively small in size with a very large capacity and thus can be used in confined spaces.

PNEUMATIC SUMP PUMPS   CP 0010 CP 0020
Weight lb 33 58
Overall Height in 16.7 20.1
Air Consumption ft ³/min 100 108
Air Inlet   3/4" NPT 3/4" NPT
Motor kW (hp) 2.2 (3) 2.9 (4)
Minimum Water Depth in 0.9 0.9
Discharge Outlet   2" NPT 21/2" BSP
Minimum Opening in 8.3 x 9.1 9.1 x 9.5
Maximum Head ft 100 89.9
Recommended Air Supply Hose Size in ¾ NPT 1 NPT
Part Number   T022224 T022185

Sludge pump

Chicago Pneumatic pneumatic pumps

Our sludge pump operates by filling the pump chamber with liquid by means of a venturi arrangement, where compressed air is forced through a restriction in the top part of the pump head, creating an under pressure within the pump chamber. The pumped liquid is then sucked into the pump hamber through an inlet valve. When the chamber is full, this triggers a valve, pressurizing the filled pump chamber. The contents of the chamber are then pressed out through the outlet port.

Our sludge pump may be operated partly submerged. It can also be used for limited suction applications, since it doesn’t need to be immersed in the liquid.

PNEUMATIC SLUDGE PUMP   CP 0077
Weight lb 152
Height in 26 ½
Minimum Opening in 23 x 11
Maximum Suction ft 20
Maximum Head ft 174
Discharge Outlet   2 1/2" NPT
Air Inlet   3/4" NPT
Recommended Air Supply Hose in 1 NPT
Part Number   T024005