Your browser is not supported

You are using a browser we do not support any longer. To continue visiting our website, please choose one of the following supported browsers.

Close

Is your Compressed Air piping Leak free & Energy efficient?

Service & Parts Air compressors Industries & applications

Compressed air system leaks are indeed a big source of energy waste. Leakage in Piping systems have been shown to exhibit leaks of up to 25 percent of the total energy costs. Addressing leaks is one of the first maintenance steps a facility can take to reduce energy costs

Your Distribution system is likely to have leaks if you experience the following;

icon airline

Operators may notice these symptoms and attribute them to poor compressor performance, but leaks are the most likely culprit.


  • You can hear it: When you walk through your system, large air leaks are audible.Take the time to walk through your system every few months to make sure large leaks aren’t costing you money

  • Loss of compressed air, even when not using it:  Any air lost when compressed air isn’t in use is solely feeding the leaks. If this happens, you most likely have lots of little leaks contributing to your air loss.
  • Unusual pressure losses: It could be a leak , if your compressor is working harder to supply the same pressure & airflow that it used to provide with ease and the pressure in your system gone down.
  • Piping system is more than five years old:Piping systems more than five years old have been shown to exhibit leaks of up to 25 percent. If your piping is outdated, consider upgrading to a new, easy to install AIRnet piping solution
  • Check Your System for Leaks to Keep Costs Low: Removing harmful contaminants from the compressed air using right periodic maintenance of the Air Filters in the system and checking on if the manual condensate drains are left open can help the compressed air to constantly leaving the system before end use.

How to Fix the Leaks 

icon recommended options

Addressing leaks is one of the first maintenance steps a facility can take to reduce energy costs.Most experts agree that the use of an ultrasonic acoustic detector is the best way to detect leaks. This device recognizes the high frequency hissing sounds associated with air leaks and uses a variety of visual and audio indicators to identify the leaks’ location.


Addressing the leaks:

  1. Leaks occur most often at joints and connections. Stopping leaks can be as simple as tightening a connection or as complex as replacing faulty equipment such as couplings, fittings, pipe sections, hoses, drains and traps.
  2. In many cases, leaks are caused by bad or improperly applied thread sealant, which can be fixed by properly installing equipment with the appropriate thread sealant.
  3. Another source of leaks can come from non-operating equipment. Equipment that’s no longer in use should be isolated with a valve in the distribution system.
  4. Lowering the demand air pressure of the compressed air system can also reduce leaks. The lower the pressure differential across an orifice or leak, the lower the rate of flow, which equals a decreased leakage rate.

Once leaks have been repaired, the compressor control system should be re-evaluated to realize the total savings potential. 

Are you interested in establishing a leak prevention program that can save your industrial facility costly repairs?